How to deal with the faults and problems in the use of construction elevators?

- Jun 07, 2019-

How to deal with the faults and problems in the use of construction elevators? 

Construction hoist is widely used in construction site and is one of the most commonly used mechanical equipment in construction. 

How to deal with the faults and problems in the use of construction elevators? 


Ⅰ. Method of making of construction hoist foundation

(1) Make construction elevator foundation according to the requirements of Product Specifications. The most maximum load that may be endured should be fully considered in design of foundation. 

(2) Drainage measures around the foundation must be set. 

Ⅱ. Safety and protection of Construction Lift

(1) Protective railings should be set up in the areas within 2.5 meters around the ground enclosure. The protective shelters with the ability of against falling objects from high altitude should be set up at the upper part of the entrance/exit. 

(2) Guardrail and foot guard boards should be installed on both sides of the bridge crossing and transport corridor between the construction elevator and each floor station, and closed by a vertical net. Normally closed safety doors should be installed at the entrance and exit. 

(3) The transport corridor or platform of each station should be constructed with 50 mm thick wooden board, and both ends of the board should be fixed. 

(4) Set up signs with dynamic and static loads. Strictly prohibit overloading operation.